Facebook social media iconTwitter social media iconInstagram social media iconSubmit to Reddit

An Introduction to Compression: Basic Compression - A free download from Audio Masterclass

An Introduction to Equalization - A free download from Audio Masterclass

Equipping Your Home Recording Studio - A free download from Audio Masterclass

New vs. old guitar strings: Part 3 - The case for conditioning your guitar strings

Make an attention-getting lo-fi introduction for a track

Puremagnetik Releases Vespine - Sounds of the EDP Wasp

Recording a cymbal from different mic positions (with audio)

'Groove' - is it all-important, or does the band just have to play the way they feel?

An interesting phase problem in drum overheads

Have your music recorded by a real symphony orchestra

Q: I have a problem with dust. Should I just grab a duster once a week?

It is illegal to copy CDs you own to your computer!

Is your mixing console noisy? Here's why...

Why do mic preamps sound different? Electrical parameters of microphones

In typical use, the output voltage from a microphone might be as small as 1 mV - one millivolt or one thousandth of a volt. This is around 60 decibels lower than the level required by a professional mixing console or recorder. So a gain of 60 dB is necessary to bring the signal from the mic up to par...

In typical use, the output voltage from a microphone might be as small as 1 mV - one millivolt or one thousandth of a volt. This is around 60 decibels lower than the level required by a professional mixing console or recorder. So a gain of 60 dB is necessary to bring the signal from the mic up to par.

The output impedance of a microphone gives a measure of its ability to supply current (it's the width of the pipe in the water tank analogy). Most modern microphones have an output impedance of around 200 ohms. If the impedance were higher, then the mic's ability to drive long cables would suffer. If it were lower, then the output voltage would also be lower, potentially degrading the signal-to-noise ratio of the system.

Since this is a small and delicate signal, it would make sense to transfer as much of it as possible to the microphone preamplifier. This would require that the mic preamp had an input impedance of 200 ohms too, which is a measure of how much current the preamp needs to draw from the mic. However, the consequence of this is that any slight variations in the output impedance of the microphone at different frequencies will lead to differences in voltage level, which is bad. So most microphone preamps have a higher input impedance of around 2000 ohms, which is a compromise that has come to be accepted over the years.

By David Mellor Thursday January 1, 2004